Vulcan-materials VPX3 ML- 126586 Manuel d'utilisateur télécharger pdf (Page 3)

– 3 –

INSTALLATION, OPERATION AND CARE OF

MODEL VPX SERIES STEAMERS

PLEASE KEEP THIS MANUAL FOR FUTURE USE

GENERAL

The Vulcan-Hart steamer cooks vegetables, frankfurters, eggs, chicken, sausage, fish, corned

beef, and many other meats and food items. These steamers are produced with quality materials

and workmanship.

The VPX3 Steamer is rated at 9.0 kW and the VPX5 Steamer is rated at 15.0 kW.

Proper installation, usage and maintenance of your steamer will result in many years of satisfactory

performance.

Thoroughly read this entire manual and carefully follow all of the instructions provided.

INSTALLATION

Before installing, verify that the electrical service agrees with the specifications on the machine data

plate located on the left side panel. If the supply and equipment requirements do not agree, do not

proceed with the installation. Contact your dealer or Vulcan-Hart immediately.

UNPACKING

This steamer was inspected before leaving the factory. The transportation company assumes full

responsibility for safe delivery upon acceptance of the shipment. Immediately after unpacking,

check for possible shipping damage. If the steamer is found to be damaged, save the packaging

material and contact the carrier within 15 days of delivery. Carefully unpack the steamer and place

in a work-accessible area as near to its final installed position as possible.

LOCATION

The installation location must allow adequate clearances for servicing and proper operation.

Minimum clearances for proper air circulation is 2" (5.1 cm) on the sides and 6" (15.2 cm) on the

back.

ASSEMBLY

This steamer comes with four 4

/2" (11.4 cm) support legs and four large flat washers. Place the

steamer on its left side, being careful to avoid scratching the finish. Place one flat washer on the bolt

side of each leg. Thread the four legs into the provided mounting holes. Do not mount steamer

directly to a counter top unless the support legs are in place.

1 2 3 4 5 6 7 8 ... 11 12

Pas de commentaire

Vulcan-materials VPX3 ML- 126586 Manuel d'utilisateur Page 3